C-1
Install the Power Share Kit
C
Use the contents of the Power Share kit to connect a dual port charging station to a single circuit.
Kit Contents
If you ordered a power sharing kit, you will receive:
•
Junction Box (1)
•
Cover (1)
•
1/4” Self-Tapping Screws to attach junction box to pedestal (2)
•
Screws to attach cover (2)
•
Wire Nuts (2)
•
Installation Instructions (repeated below)
Install the Power Share Kit
1.
Using the two supplied screws, attach the junction box to the
pedestal, as shown.
1.
Run the L1 and L2 service wires into the hole into the hole in the
bottom of the junction box.
NOTE:
Maximum wire size is 6AWG.
1.
Twist two 10-gauge wires (approximately 18” long) onto each of
the service wires and secure using wire nuts.
1.
Route a 10-gauge wire to each of the charging stations.
1.
Attach the cover to the junction box by hand-tightening the two
supplied screws.
IMPORTANT !
Please note which units (as identified on the activation label) are sharing a circuit. The information on the
activation labels, in addition to the breaker panel ID and breaker number, MUST be provided during the
activation process (see Post-Installation Checklist on page 5-3).
