6-1
Troubleshooting
6
After installing the station(s), you must verify that:
•
the output cable wiring is properly installed
•
the small blue wire on the output cable is fully inserted into the connector on the terminal block
•
wires are not laying parallel to the back face
Check the Status Light
When the station is powered on and activated, the status light on the front of the station illuminates as follows:
OFF: Idle (including vehicle plugged in but not authorized)
Pulsing Yellow: Authorization in progress
Pulsing Green: Card is approved and schedule is set to delay charging
Solid Green: Card is approved and station is ready to charge
Pulsing Blue: Vehicle is charging
Solid Blue: Vehicle is plugged in but is not yet charging (or vehicle is fully charged)
Solid Red: Card is denied (temporary) or a fault has occurred (permanent)
