page 45
www.centsys.com
FIGURE 77
Connect the Earth Harness into the
right-hand side of the Charger at
Point "E".
Charger
Earth
Harness
E
FIGURE 76
FIGURE 75
Charger
Harness
C
A B
D
7.10.5. Reconnecting the Harnesses to the Control Card and Charger
Reconnect the Motor Wires at
Position "A" and the Override
Harness at Point "B" on the Control
card.
Reconnect the Charger Harness
to the point from which it was
disconnected earlier, either at
Position "C" or at Position "D".
If the connection is made
at Point "C", note that
there are two connector
blocks that need to be
reconnected to the
Control Card.
Utilise the Cable Retainers
at the bottom of the
accessory storage to neaten
up the wiring, and the
overall installation.
A
B
The black motor wire
is connected on the
far Left of the Control
Card, and the blue on
the immediate right of
the black.