page 31
www.centsys.com
Once the Cable Shield has been removed, place the D5 SMART into position over the
three Mounting Bolts, aligning them with the three slots at the bottom of the gearbox
and rest the D5 SMART onto the Bottom Height Adjusters.
Once the Gearbox is resting on top
of the Bottom Height Adjusters, slide
the D5 SMART as far as possible
towards the gate to allow for later
adjustment.
FIGURE 39
Gearbox
FIGURE 40
FIGURE 38
OPERATOR INSTALLATION
SECTION 7
Slots
TOP VIEW
Mounting
Bolt
Foundation
Plate
Mounting
Bolt
The Cable Shield needs to be removed before mounting the D5 SMART onto its
Foundation Plate. This is done by levering the bottom end of the cable shield away from
the motor until it unclips from the gearbox, and then slide it up.
Step 1
Step 2
Cable
Shield
Cable
Shield
Removing the Cable Shield
