41
5. Install the optic labeled CEI/SR3 S16 for Super 16, or
remove it for standard 16.
6. Tighten the clamp screw on the retrofit using a 3/32-inch hex
driver, then screw the elbow assembly securely into the face
of the CEI Color Six .
7. Loosen the clamp screw: This allows pivoting of the Color
Six to the desired position relative to the elbow.
8. Mount the elbow and Color Six camera assembly securely to
the SR-3
9. Pivot the Color Six to the desired position. If using a CEI
SR-3 support bracket, rest the color camera against the clear
pad on the support bracket and screw the restraining bolt into
the appropriate hole such that it lightly seats against the
Color Six .
10. Tighten the clamp screw using a 3/32-inch hex driver.
Focus and iris functions will be as normal on the Arri elbow.
Focus adjustments should be made with the iris fully open.
To adjust picture size, perform the following steps:
For Super 16
1. Locate the slot in the mount clamp near the face of the Color
Six .
2. Using a 1/16-inch hex key (normally part of the Color Six ),
access the inner ring through the slot.
3. Change the picture size: Rotate the inner cell by inserting the
hex key into one of the holes along the inner ring and turning
it.
4. Refocus