CBE 520, Safety, Installation, Operation, Maintenance

Page: 47 / 61

47
◙ If correctly connected, try a Calibration Reset. Press <
CAL > and when "FirstZero?"
is displayed press < SELECT > until Cal Reset is displayed. Press < ENTER > to reset
and recalibrate the indicator.
◙ If Calibration Reset does NOT work, hook a load cell simulator up to the indicator to
test and make sure indicator is working correctly.
Troubleshooting
◙ If load cell simulator works fine, hook the load cell back up to the indicator.
◙ Go into setup: 100<
SELECT >23640< TIMERS & ADJUST >< ENTER >
◙ Key in 110<
SELECT > and enter a weight HIGHER than currently in the indicator. If
100 lbs, set to 250. To do this, just key in the desired weight and press < ENTER >.
◙ Once the desired weight is entered, press <
ZERO >, when prompted "Enter=Cal!"
press < ENTER > and proceed through calibration.
◙ Once calibrated, if "Cal good?" displays on indicator, press <
ENTER > through
remaining prompts.
Troubleshooting
◙ Once back in weigh mode, re-enter setup and go back to parameter 110.
◙ Change the newly keyed in value back to original weight value, and proceed to
calibrate once again by pressing < ZERO > and < ENTER > to re- calibrate.
◙ USE THE NEXT STEPS AS A LAST RESORT!
◙ If this still does NOT fix the issue, the indicator MAY need to be defaulted at P65001.
Key in 100< SELECT >23640< TIMERS & ADJUST >< ENTER > to enter setup.
◙ Key in 65001<
SELECT > to get "Defit All" and press < ENTER > through the prompts.
◙ The program will NEED to be reloaded and the indicator re-calibrated.