CAVRO XP 3000, Operator'S Manual, Page: 47 / 134

Software Communication
3-11
6 Select the File menu, and choose Properties . The Properties dialog box appears.
7
Select the Settings tab, and enter or select these options:
Function, arrow, and Control keys act as:
–
Select “Terminal keys”
Emulation:
– Select “Autodetect”
–
Enter “500” in Backscroll buffer lines
Click the ASCII Setup button. The ASCII Setup dialog box appears.
8
Enter or select these options:
– Select “Send line ends with line feed”
–
Select “Echo typed characters locally”
– Enter a Line delay of “0”
– Enter a Charater delay of “0”
– Select “Wrap lines that exceed terminal width”
9
Click OK to close the ASCII Setup dialog box, then click OK to close the Properties
dialog box.
10
Set the pump address to 0 or the appropriate address.
11
Set jumper JP1-2 to DT protocol (JP1-2 removed). Note that no jumper is needed for
microstep-enabled firmware. The communication protocol is detected automatically.
12
Power on the pump and initialize it by typing /1ZR and pressing Enter .
To run the pump, see the commands listed in “Using the XP 3000 Command Set” in
this chapter.