SOHOSpeed ADSL2/2+ Ethernet/Wireless Gateway User’s Manual
46
3.7 ADVANCED
The Advanced tab allows you to perform advanced configuration functions for existing
connections including:
z
Enabling and disabling of key features including voice, voice provision, UPnP, SNTP,
SNMP, TR-069, IP QoS, RIP, access control, TR-068 WAN access, and multicasting
z
QoS (ingress, egress, shaper) and policy routing
z
Management of LAN port interfaces, packet flow, and filtering
At least one WAN connection must be configured before implementing advanced WAN
configuration features. At least one LAN group must be defined before implementing
advanced LAN configuration features.
3.7.1 UPnP
Universal plug and play (UPnP), NAT, and firewall traversal allow traffic to pass through the
SOHOSpeed for applications using the UPnP protocol. This feature requires one active WAN
connection. In addition, the PC should support this feature. In the presence of multiple WAN
connections, select a connection on which the incoming traffic is present, for example, the
default WAN connection.
1.
Check
Enable UPnP
.
This enables the WAN Connection and LAN Connection fields.
2.
Select the WAN Connection and LAN Connection that will use UPnP from the drop-
down lists.
3.
Click
Apply
to temporarily activate the settings.
Note:
The changes take effect when you click Apply; however, if the SOHOSpeed
configuration is not saved, these changes will be lost upon SOHOSpeed reboot.
4.
To make the change permanent, click
Tools
at the top of the page and select
System
Commands
.
5.
At the
System Commands
page, click
Save All
.
