SOHOSpeed ADSL2/2+ Ethernet/Wireless Gateway User’s Manual
13
1.
At the
Setup
main page, click
New Connection
.
The default PPPoE Connection Setup page is displayed.
2.
In the
Name
field, enter a unique name for the PPPoE connection.
The name must not have spaces and cannot begin with numbers. In this example, the
unique name is PPPoE.
3.
The
Network Address Translation
(NAT) and the
Firewall
options are enabled by
default. Leave these in the default mode.
Note:
NAT enables the IP address on the LAN side to be translated to IP address on the
WAN side. If NAT is disabled, you cannot access the Internet.
4.
If you want to enable VLAN, refer to the table below to configure the following fields:
z
Sharing: Select VLAN to enable the
VLAN ID
and
Priority Bits
fields.
z
VLAN ID: Enter the VLAN ID.
z
Priority Bits: Select the priority bits of the VLAN.
5.
In the
PPP
Settings section, enter values from DSL service provider or your ISP.
6.
In the
PVC
Settings section, enter values for the
VPI
and
VCI
.
Note:
Your DSL service provider or your ISP supplies these values. In this example, the
DSL service provider is using 0,33.
7.
Select the
Quality of Service
(QoS).
Leave the default value if you are unsure or if the ISP did not provide this information.
8.
Click
Apply
to complete the connection setup. This temporarily activates this connection.
A
B
C
