![CastleNet Technology Inc. ASW802 User Manual Download Page 24](http://html1.mh-extra.com/html/castlenet-technology-inc/asw802/asw802_user-manual_2573099024.webp)
SOHOSpeed ADSL2/2+ Ethernet/Wireless Gateway User’s Manual
23
Field Description
Field
Definition/Description
Encapsulation
The technique used by layered protocols in which a layer adds header
information to the protocol data unit (PDU) from the layer above. As an
example, in Internet terminology, a packet would contain a header from the
data link layer, followed by a header from the network layer (IP), followed by
a header from the transport layer (TCP), followed by the application protocol
data. Two encapsulation options are provided:
z
Logical Link Control (LLC)
z
Virtual Channel (VC)
Select LAN
Select the LAN group for the bridged connection. The following options are
available:
z
LAN Group 1
z
LAN Group 2
z
LAN Group 3
z
None
This bridged connection will be added to the selected LAN group. If you
select None, the connection is not added to any LAN group but to the
Interfaces box on the
LAN Configuration
page, which can be configured to
a LAN group on the same page.
For VLAN and PVC field descriptions, please refer to section 3.4.1.
Classical IP over ATM Connection Setup
CLIP, defined in RFC 2225, provides the ability to transmit IP packets over an ATM network.
This SOHOSpeed’s CLIP support encapsulates an IP datagram in an AAL5 PDU frame using
RFC 2225 and it uses an ATM-aware version of the address resolution protocol (ATMARP).
Its CLIP support only allows support for PVCs, SVCs are not supported by the SOHOSpeed.
1.
On the
Setup
main page, click
New Connection
.
The default
PPPoE Connection Setup
page is displayed.
2.
From
Type
drop-down box, select
CLIP
.
The default
CLIP Connection Setup
page is displayed.
3.
Enter a unique name for the static connection in the
Name
field.
The name must not have spaces and cannot begin with numbers. In this example, the
unique name is Clip.
4.
The
Network Address Translation
(NAT) and the
Firewall
options are enabled by
default. Leave these in the default mode.
5.
Based upon the information your DSL/ISP provided, enter your assigned I
P Address
,
Mask
,
ARP Server
, and
Default Gateway
.