SOHOSpeed ADSL2/2+ Ethernet/Wireless Gateway User’s Manual
27
3.5 Configuring the LAN
The SOHOSpeed provides LAN configuration for multiple LAN bridge groups. Up to five LAN
bridge groups are supported. The LAN interefaces could include: Ethernet, USB, WLAN
(Primary SSID), SSID1, SSID2, and SSID3. It is possible to assign any LAN interface to any
bridge group but only one group, except that the Ethernet interface needs to stay in LAN
group 1. Each LAN group can then be configured with static IP address, dynamic IP address,
or be unmanaged (no IP).
The default LAN Configuration page shows the LAN interfaces that belong to a single LAN
bridge group (LAN Group 1):
z
USB
z
Ethernet
z
WLAN
Note:
The following interfaces are not valid until multiple SSID is enabled and the secondary
SSIDs are configured:
z
SSID1 (corresponds to the first secondary SSID)
z
SSID2 (corresponds to the second secondary SSID)
z
SSID3 (corresponds to the third secondary SSID)
For more information on how to configure multiple SSIDs, refer to ‘‘Multiple SSID’’.
The SOHOSpeed performs routing between the LAN group 1 and the WAN connections as
shown in figure below.
