Case IH RBX443, Repair Manual

Page: 93 / 196

SECTION 55 - ELECTRICAL SYSTEMS - CHAPTER 1
55-3
DESCRIPTION OF OPERATION
PROTECTING THE ELECTRICAL/
ELECTRONIC SYSTEMS DURING
CHARGING OR WELDING
To avoid damage to the electrical/electronic systems,
always observe the following precautions:
1. Position the welder ground cable clamp as close
to the welding area as possible.
2. If welding is required near the controller, then the
controller should be removed from the baler.
3. Always unplug the tractor from the baler before
performing any welding service to the baler.
4. Never allow welding cables to lay on, near, or
across any electrical wiring or electronic compo-
nent while welding.