Case IH RBX443, Repair Manual

Page: 132 / 196

SECTION 62 - PRESSING - CHAPTER 2
62-4
5. On the right side, remove lock collar, 1, and cap
screws, 2. Remove flangettes and bearing, 3.
The roll can now be removed through the front of
the baler.
3
19993063
2
1
2
5
Installation
1. Slide the roll assembly into the baler. On the
right-hand side, install the bearing assembly at
the shaft. Use a longer bolt at 1 and drift punch,
2, to assist in installing bolt, 3.
NOTE: Be sure to position the end shield with the
screw exposed in the slot as shown. The purpose of
the screw is to be able to rotate the shield to align the
holes for the bolts.
2. Install the remaining hardware and lock collar.
Do not tighten at this time.
3
19993064
2
1
6
3. Install the left-hand bearing, 1, and hardware, 2.
Do not tighten the hardware at this time. Install
the same number of shims, 3, that were removed
in disassembly. Install woodruff key, 4.
2
1
19993065
3
4
2
7