CAS NT-580A, Manual, Page: 55 / 87

56
7-5. Set Point Input
The Set Point input is used to set the value of each point for the three step control in the batching
operation.
The Set Point is allotted according to the designated Item code in ‘7-4’ and can be inputted from
Set Point 1 to Set Point 7.
The Set Point value can be inputted in the four following ways
- The way to input with the keys in the Weighing Mode.
- The way to input with the external BCD Code in the Weighing Mode.(Option)
- The way to input with the keys in the Set Mode.(Refer to page 50)
- The way to input through the RS-232C, RS-485 communication. (Refer to page 41)
if pressing ▣ the “ * ” key for 2 sec, the Weighing Mode is changed to the Set Point input
Mode and then the set value should be inputted directly.
Ref 1. Set the value of F73 in the set Mode to 1.
Ref 2. Move the digit with the “ ▶ , ◀ ” key and then move to the next step with the “ ▲ , ▼ ” key after
inputting the setting value.
Press the “ * ” key to leave the Set Mode without saving.
Set Point No DISPLAY DESCRIPTION
ZEro bA
Set Point-1
1-00000
o Input is started by pressing the " ENTER " key.
o It means the zero band.
oP-Pre
Set Point-2
2-00000
o It means the Optional Preliminary.
o Input the Optional Preliminary.
PrELiM
Set Point-3
3-00000
o It means the Preliminary Weight.
o Input the Preliminary Weight.
FinAL
Set Point-4
4-00000
o It means the Final Weight.
o Input the Final Weight.
FALL
Set Point-5
5- 0000
o It means the Free Fall Weight.
o Input the Free Fall Weight.
H-LiMit
Set Point-6
6- 0000
o It means the High Limit Weight.
o Input the High Limit Weight.
L-LiMit
Set Point-7
7- 0000
o It means the Low Limit Weight.
o Input the Low Limit Weight.