CAS NT-580A, Manual, Page: 22 / 87

23
CAL 3-3
Function : Setting Weight value
Setting value range : 1 ~ 99,999
USED KEY VFD SCREEN DESCRIPTION
LOAD 1
It means setting weight value mode.
(number = multi calibration number)
W=100.00
100.00 (Unit : Kg or Ton)
▲ , ▼ : increase or decrease of
no.
▶ , ◀ : Shift of digit
”* " : Cancel and
move to CAL-1
Enter : Store and move
into next menu
W= 0.10
0.10 (Unit : Kg or Ton)
Ref 1. Set the weight value within 10% ~ 100% range of maximum weight.
At the beginning , it has been automatically set 100% of maximum weight.
If the actual weight value is different from manimum weight, reenter the weight value which you have.
(If weight value exceeds maximum weight, error massage “Err 23” will be displayed.
If weight value is below 10% of maximum weight, error massage “Err 20” will be displayed, and the
accuracy will be decreased under 10%.)
CAL 3-4
Function : Weight Calibration
USED KEY VFD SCREEN DESCRIPTION
LoAd
Load the weight that you set in CAL3-3 on
load receptor and press “ENTER” key.
12345
Present weighing value is displayed.
Check stability, press “ENTER” key.
”* " : Cancel and
move to CAL-1
Enter : Store and move
into next menu
- - -
In the setting span..
Ref 1. Perform repeatedly CAL3-3, CAL3-4 as the number of times as you set step in CAL3-1.
At this time, weight value should be set as higher value than previous value.
Ref 2. If setting span is complete without errors, move to CAL-1.
Ref 3. If span value is low, error massage “Err 24” will be displayed.
Ref 4. If span valus is high, error massage “Err 25” will be displayed.