Carrier 69NT40-561-300, Operation And Service Manual

Page: 169 / 174

Index-1 T-365
INDEX
Numerics
230 Volt Cable 2–3
460 Volt Cable 2–3
A
Adding Refrigerant to System (Full Charge) 7–7
Adding Refrigerant to System (Partial Charge) 7–7
Adjust Fresh Air Makeup Vent 5–2
Air-Cooled Condenser Section 3–4
Alarm Configuration (dCF07 - dCF10) 4–21
Assemble the Evaporator Fan Assembly 7–18
Autotransformer 2–2
,
7–28
B
Back Panels 2–3
Battery 2–2
C
Cable Restraint 2–3
Check Controller Function Codes 5–7
Checking eAutoFresh Drive System 7–41
Checking High Pressure Switch 7–12
Checking the Controller 7–42
Checking the Refrigerant Charge 7–7
Communications Interface Module 2–2
,
3–5
Communications Interface Module Installation 7–44
Complete Inspection 5–7
Compressor 2–1
,
7–8
Compressor High Temperature Protection 4–14
Compressor Low Pressure Protection 4–14
Compressor Section 3–3
Condenser Coil 2–1
,
7–13
Condenser Coil Cleaning 7–13
Condenser Coil Installation 7–14
Condenser Coil Preparation 7–14
Condenser Coil Removal 7–13
Condenser Fan and Fan Motor 7–15
Condenser Fan Motor Remove/Replace 7–15
Condenser Fan Operation 2–1
Condenser Fan Override 4–15
Condenser Grille 2–3
Configuration Identification 2–1
Configuration Software (CnF Variables) 4–4
Connect Power 5–1
Connect Remote Monitoring Receptacle 5–6
Connection To 190/230 VAC Power 5–1
Connection To 380/460 VAC Power 5–1
Control Box 2–1
Control Box Section 3–5
Controller 2–3
,
4–3
,
7–29
Controller Alarm Indications 4–39
Controller Alarms 4–15
Controller Configuration Variables 4–24
Controller Function Codes 4–26
Controller Pre-Trip Test Codes 4–53
Controller Sequence and Modes of Operation 4–5
Controller Software 4–4
Controller Troubleshooting 7–29
D
DataCORDER 4–16
DataCORDER Alarms 4–23
DataCORDER Communications 4–22
DataCORDER Description 4–16
DataCORDER Power Up 4–21
DataCORDER Software 4–18
Defrost 4–12
Defrost Operation 4–12
Defrost Related Parameters 4–13
Dehumidification 2–2
Digital Loader Valve 7–24
Digital Unloader Valve 7–26
Disassemble the Evaporator Fan Assembly 7–18
Display Module 4–3
E
eAutoFresh 2–3
eAutoFresh Modes of Operation 5–5
eAutoFresh Operation 5–4
eAutoFresh Pre − Trip Inspection 5–4
eAutoFresh Service 7–41
eAutoFresh Start-Up Procedure 5–4
Economized Operation 3–9
Economizer Expansion Valve 7–22
Economizer Solenoid Valve 7–21
Electrical System Data 3–7
Electronic Expansion Valve 7–20
Evacuation and dehydration 7–5
Evacuation and Dehydration, Complete System 7–6
Evacuation and Dehydration, General 7–5
Evacuation and Dehydration, Partial System 7–6
Evacuation and Dehydration, Preparation 7–5
Evaporator 2–1
Evaporator Coil & Heater Assembly 7–16
Evaporator Coil Replacement 7–16