CapstanAG PinPoint III ENVELOP, Operator'S Manual

Page: 42 / 128

TM
Operation
Nozzle Bounds
Line Title Line
Number
Description
7 Valve
Diagnostics
If the system is not using nozzles that use the CapstanAG nozzle
diagnostics properly, the nozzle diagnostics can be disabled here.
CapstanAG uses this feature on demonstration units and development
units where lights are substituted for valves or reset to Coil Only. Coil Only
disables the plunger movement detection without disabling short or open
data.
Nozzle Setup
This screen is used to change nozzle information and to set the profile icons. For more information,
see
Do the Nozzle Setup Procedure .
Pressure Settings Menu Descriptions
Pump Setup
Line Title Line
Number
Description
Servo Type 1
Select the correct servo type for your machine.
Servo Minimum 2
The servo minimum value is the minimum duty cycle that the pump will be driven. It
is important that this value corresponds with the minimum duty cycle used by the rate
controller.
Servo Maximum 3
The servo maximum value is the maximum duty cycle that the pump will be driven. It
is important that this value corresponds with the maximum duty cycle used by the rate
controller.
Servo Man Speed 4
The servo manual speed controls how fast the pressure changes in manual mode. If the
valve operates too slowly in manual mode, increase this value. If the valve operates too
quickly in manual mode, decrease this value.
Pump Seal Shutdown 5
When the sensor falls below the pump seal shutdown value, the pump shuts off to prevent
the pump from operating dry and causing pump seal failure.
Pump Pulses/Rev 6
On sprayers that are equipped with a pump speed sensor, use this feature to limit the
maximum pump speed to the selected pump pulses per revolution (RPM).
©
2021 Capstan Ag Systems, Inc.
42
PinPoint
™
III ENVELOP