CapstanAG PinPoint III ENVELOP, Operator'S Manual

Page: 101 / 128

TM
Troubleshooting
Table 2: Valve Fault Codes
Fault Code
and Message
Fault Cause Correction
Fault 500: Valve
Lodged Open Valve Lodged
Open Debris in the valve Clean the valve
Fault 501: Valve
Lodged Closed Valve Lodged
Closed Debris in the valve Clean the valve
Fault 502: Coil
Circuit Open Coil Circuit
Open Coil wire is pinched, cut,
broke or disconnected Do a check of the coil connection
and resistance:
• 7-watt coils resistance—21
ohms to 23.5 ohms
• 12-watt coils resistance—
10 ohms to 11.5 ohms
Fault 503: Coil
Circuit Short Coil Circuit
Short Internal coil short: Coil wire
is pinched, cut, or broke Do a check of the coil connection
and resistance:
• 7-watt coils resistance—21
ohms to 23.5 ohms
• 12-watt coils resistance—
10 ohms to 11.5 ohms
If you do have an extra valve,
do the factory reset procedure to
correctly setup the system. Fault 504: Extra
Coil Extra Coil A valve has been sensed
on a VCM after the system
was setup.
If you d not have additional
valve(s) there is a VCM problem
and you must repair or replace
the VCM.
©
2021 Capstan Ag Systems, Inc.
101
PinPoint
™
III ENVELOP