CapstanAG PinPoint III ENVELOP, Operator'S Manual

Page: 109 / 128

TM
Troubleshooting
Do a Check of the System Load Capacity
1. Start the engine of the machine.
2. Turn on all the boom sections.
3. Turn on all of the electrical loads, including the air conditioning, foam marker monitors, etc.
4. See what the voltage readout on the correct settings screen on the display.
The nozzle valves operate best at 12 VDC or higher. Using less than 12 VDC will result in reduced
pressure capacity. This will often result in erratic nozzle pulsing, sometimes described as flickering.
Also, do a check of the nozzle valves for worn plunger seals.
If low voltage is observed, do a check of:
• The battery terminals and clean as necessary
• The condition of the battery
• The condition of the alternator
• The condition of the connections
©
2021 Capstan Ag Systems, Inc.
109
PinPoint
™
III ENVELOP