Canon VB-H610D, Operation Manual

Page: 51 / 173

51
S
et
ting P
age
5
Camera Name
[Camera Name]
Be sure to enter [Camera Name (alphanumeric
characters)].
Up to 15 ASCII characters (spaces and printable
characters) may be used for [Camera Name
(alphanumeric characters)].
Note
• The camera name set here will be shown when the camera is
registered for use with included RM-Lite.
Initial Camera Settings
(1) [AE Mode], [ S low S hutter], [ S hutter S peed]
Set the exposure control and shutter speed for the
camera startup.
[AE Mode]
[Auto]
The exposure is controlled automatically.
[Auto (Flickerless)]
In this mode, image flickers caused by fluorescent
lights, etc., can be reduced. The shutter speed is
automatically adjusted according to the brightness
of the environment in which the camera is used.
[Auto (Shutter-priority AE)]
In this mode, a desired shutter speed can be
specified.
[ S low S hutter]
Slow shutter can be used only if [Auto] is selected in
[AE Mode].
Set the maximum slow shutter time to be used when
in auto exposure mode when capturing video in a
dark place. Select [Disable], [1/15], [1/8], [1/4] or
[1/2]. As slower shutter speed generates residual
images when capturing a moving subject, select an
appropriate time according to the capture conditions.
[ S hutter S peed]
Shutter speed can be used only if [Auto (Shutter-priority
AE)] is selected in [AE Mode].
Select a desired shutter speed from the 16 levels from
[1/2] to [1/16000]. When capturing a moving subject,
selecting a higher shutter speed can reduce blurry image
capture.
(2) [Exposure Compensation]
The exposure compensation when the camera starts
can be set in the range of [-4 (Dark)] to [4 (Bright)]. To
brighten the image, set a positive value. To darken the
image, set a negative value.
(3) [Metering Mode]
Set the metering mode when the camera starts.
[Center-Weighted]
The entire screen is metered by focusing on the
center of the screen.
Even when slightly darker/brighter areas are present
on the periphery of the screen, an appropriate
exposure can be achieved for the subject near the
center.
Use this mode if the subject is positioned near the
center of the screen.
[Camera] Setting Initial Camera Settings and External Device Name
The following can be set here.
• Camera Name
Enter the name of the camera. The camera name
is required for use with RM-Lite.
• Initial Camera S ettings
Sets shooting settings at camera start up.
• Camera Control
Set the digital zoom, image stabilizer and AGC
limit.
• Day/Night
Set the day/night switching mode.
• Installation Conditions
Sets installation conditions, such as LED settings.
• Camera Position Control
Set whether or not to limit the pan, tilt and zoom
operations to the preset positions. Also, set the
camera position when nobody has control
privileges.
• External Device Name
Set the external input device name and external
output device name.