2) Defective paper delivery sensor lever
Action:
Replace the sensor lever if damaged.
3) Defective paper top sensor spring
Action:
Replace the spring if damaged.
4) Defective paper top sensor lever
Action:
Replace the lever if damaged.
5) Defective engine controller PCB
Action:
Replace the engine controller PCB.
VI-4.
The printer cannot enter the READY mode and the "door open status" is output,
although the door is closed after installing the cartridge,
<Possible causes>
1) Damaged connector holder claw of the door switch ON/OFF.
Action:
Replace the connector holder.
2) Defective door open detection unit
Action:
Replace the door open detection unit.
3) Defective door open detection switch
Action:
Replace the door open detection switch (SW301.)
4) Defective engine controller PCB
Action:
Replace the engine controller PCB.
VI-5.
The printer cannot enter the READY mode and the "paper out status" is output,
although paper is set.
<Possible causes>
1) Defective paper out sensor lever
Action:
Replace the paper out sensor lever if damaged.
2) Defective paper out sensor
Action:
Replace the paper out sensor (PS003.)
3) Defective engine controller PCB
Action:
Replace the engine controller PCB.
VI-6.
The printer cannot enter the READY mode and the "no cartridge status" is output,
although the cartridge is installed.
<Possible causes>
1) Poor contact in the primary high-voltage contact on the engine controller PCB and cartridge
contact.
Action:
Clean the contacts if dirty. If the problem still remains after cleaning, or parts are
deformed or damaged, replace them.
CHAPTER 4
4 - 18
