Canon imagePASS-P1, Service Manual, Page: 46 / 70

16. Power on the printer using the main power switch.
Allow the imagePASS to start up and reach Idle (00 should appear on the imagePASS LED display).
NOTE:
If you press the Fiery icon on the printer touch panel before the imagePASS finishes the startup process, “TCP connect error”
appears on the printer touch panel. Press OK to return to the main menu, and wait until the imagePASS reaches Idle.
Wait approximately five minutes longer for the imagePASS Start page to print.
17. If you saved a configuration file earlier, restore the system configuration (see “Backing up and restoring the system
configuration” on page 36 ).
NOTE:
If it was not possible to save a configuration file or if you installed an upgraded version of system software, you must configure
Setup using the Configuration pages you printed earlier. For information about performing Setup, see Configuration and Setup,
which is part of the user documentation set. Bypass any settings if it is more appropriate for the site administrator to set them.
After you exit Setup and allow the system to reboot, ask the site administrator to restore the custom files that were archived earlier.
18. Install any required software patches:
• If you reinstalled the same version of system software, be sure to reinstall all software patches that were previously
installed on the imagePASS. For a list of installed patches, see the Configuration pages that you printed earlier.
• If you installed an upgraded version of system software (for example, version 1.0 to version 2.0), contact your authorized
service/support center for a list of valid software patches. Some or all of the patches listed on the Configuration pages
that you printed earlier may no longer be valid. Before installing a patch, be sure to verify with your authorized service/
support center that it is valid for your system version. Installing an invalid patch may result in system corruption.
19. Reconnect any USB devices that you may have removed earlier.
20. If the imagePASS requires a static IP address (for example, in a non-DHCP network environment), work with the network
administrator to configure it (see the Configuration and Setup which is part of the user documentation).
Fiery Clone Tool
With the Fiery Clone Tool, you can copy the contents of the imagePASS hard disk drive to an image file, and then save the image
file to a folder on the imagePASS hard disk drive or a USB storage device connected to the imagePASS. For more information,
see the documentation that accompanies the Fiery Clone Tool.
Printing the Configuration pages
This section describes how to print the Configuration pages. The Configuration pages list all installed options on the imagePASS,
as well as the customer’s current Setup configuration (for more information, see
“Installing System Software” on page 36 ).
To print the Configuration pages
1. From the printer control panel, press Main Menu button. If the Fiery icon does not appear on the copier touch panel, press
Show All.
2. From the printer touch panel, select Fiery > Info > Print pages > Configuration.
Wait for the Configuration pages to print.
4. INSTALLING SYSTEM SOFTWARE
41