Canon imagePASS-P1, Service Manual, Page: 23 / 70

2. To release a DIMM, push outward on the levers on each side of the DIMM (see blow Figure)
1
2
3
1
Figure 11: Releasing a DIMM
No. Item
1 Lever
2 DIMM
3 Socket notch
3. Lift the DIMM straight out of the socket.
4. To replace a DIMM, position the DIMM in the socket and press the DIMM straight down into the socket, so that the levers
lock the DIMM into place (see above Figure).
NOTE:
DIMM fits in the socket only one way. The notch on the bottom of the DIMM should line up with the notch in the socket.
Make sure that the levers close securely around the ends of the DIMM and that the DIMM is fully seated in its socket.
5. Reassemble the imagePASS and verify its functionality (see “Restoring imagePASS functionality after service” on page
34 ).
■ Motherboard
This section describes the battery and default jumper settings on the imagePASS motherboard, as well as procedures for
removing and replacing the motherboard.
Battery
The battery is located on the motherboard. Spare batteries are not provided by your authorized service/support center. If you
must replace the battery, use a 3V manganese dioxide lithium coin cell battery (Panasonic CR2032 or equivalent).
CAUTION:
There is a danger of explosion if the battery is replaced with the incorrect type. Replace it only with the same type
recommended by the manufacturer. Dispose of used batteries according to the manufacturer’s instructions.
ACHTUNG: Es besteht Explosionsgefahr, wenn die Batterie durch eine Batterie falschen Typs ersetzt wird. Als Ersatz dürfen
nur vom Hersteller empfohlene Batterien gleichen oder ähnlichen Typs verwendet werden. Verbrauchte Batterien müssen
entsprechend den Anweisungen des Herstellers entsorgt werden.
ATTENTION : Il y a risque d’explosion si la pile est remplacée par un modèle qui ne convient pas. Remplacez-la uniquement par
le modèle recommandé par le constructeur. Débarrassez-vous des piles usées conformément aux instructions du constructeur.
ADVARSEL!: Lithiumbatteri - Eksplosionsfare ved fejlagtig håndtering Udskiftning må kun ske med bat-teri af samme fabrikat
og type. Levér det brugte batteri tilbage til leverandøren.
VAROITUS: Paristo voi räjähtää, los se on virheellisesti asennettu. Vaihda paristo ainoastaan laitevalmistajan suosittelemaan
tyyppiin. Hävitä Käytetty paristo valmistajan ohjeiden mukaisesti.
3. REPLACING PARTS
18