Canon imagePASS-P1, Service Manual, Page: 21 / 70

IMPORTANT:
Be sure to use an ESD grounding wrist strap and follow standard ESD (electrostatic discharge) precautions while performing
these procedures. For details, see
“Precautions” on page 3 .
NOTE:
There may be tie-wraps used to secure the cables to the chassis. If necessary, cut these tie-wraps before removing the
components.
■ Printer interface board
The printer interface board is installed in PCIE x16 on the motherboard.
1
2
3
Figure 9: Detail of printer interface board (component side)
No. Item
1 Printer interface cable connector
2 PCIE x16 connector
3 J351 connector for 10-pin power button cable to motherboard J15
To remove the printer interface board
1. Access and open the imagePASS, as described on “Accessing the imagePASS” on page 13 .
2. Remove the 10-pin power button cable from J351 connector that connects between the printer interface board and the
motherboard.
3. REPLACING PARTS
16