Canon C3220, Copying Manual

Page: 260 / 372

Using Image Creation Modes
6-14
6
Special Cop
ying F
eatures - Image Editing
NOTE
•
If you make a mistake when entering values, press [C] on the inch entry pop-up
screen
➞
enter the correct values.
•
To enter values in millimeters, press [mm].
•
When entering values in millimeters, you can also use - (numeric keys), and
(Clear) to clear your entries.
•
If you enter a value outside the setting range for [X1], [X2], [Y1], or [Y2], a message
prompting you to enter an appropriate value appears on the screen.
•
For instructions on entering values in inches, see Chapter 2, "Basic Operations," in
the
Reference Guide .
•
To change a value you entered, press [X1], [X2], [Y1], or [Y2]
➞
enter the correct
value using the numeric keys on the inch entry pop-up screen.
•
To check the designated area, press [Check Area].
•
To clear all your entries, press [Clear Area].
7
Press [OK]
➞
[Done]
➞
[Done].
The selected mode is set, and the display returns to the Copy Basic Features
screen.
8
Press (Start).
If you need to designate the same area for multiple originals using the edit pen,
remove the original from the platen glass after specifying the area
➞
place all of
the originals into the feeder
➞
press (Start).
Copying starts.
NOTE
•
To cancel this setting, press [Special Features]
➞
[
▼
]
➞
[Image Creation]
➞
[Image Repeat]
➞
[Cancel].
•
To cancel all settings and return the machine to the Standard mode, press
(Reset).