Cambium Networks PTP 450 Series, Configuration Manual

Page: 158 / 649

Chapter 1: Configuration Configuring security
Page
1-130
Bypass
Authentication for ICC
SMs
Enabled: SM authentication is disabled when SM connects via ICC
(Installation Color Code).
Disabled: SM authentication is enabled.
Encryption Setting Specify the type of airlink security to apply to this AP. The encryption
setting must match the encryption setting of the SMs.
None provides no encryption on the air link.
AES (Advanced Encryption Standard): An over-the-air link encryption
option that uses the Rijndael algorithm and 128-bit keys to establish a higher
level of security. AES products are certified as compliant with the Federal
Information Processing Standards (FIPS 197) in the U.S.A.
Note
This parameter is applicable to BHM.
SM Display of AP
Evaluation Data
Or
BHS Display of BHM
Evaluation Data
Allows operators to suppress the display of data about this AP/BHM on the
AP/BHM Evaluation tab of the Tools page in all SMs/BHS that register. The
factory default setting for SM Display of AP Evaluation Data or BHS Display
of BHM Evaluation Data is enabled display.
PMP 450/450i Series – SM display of AP Evaluation Data parameter
PTP 450/450i Series – BHS display of BHM Evaluation Data parameter
Web, Telnet, FTP
Session Timeout Enter the expiry in seconds for remote management sessions via HTTP,
telnet, or ftp access to the AP/BHM.
IP Access Control You can permit access to the AP/BHM from any IP address (IP Access
Filtering Disabled) or limit it to access from only one, two, or three IP
addresses that you specify (IP Access Filtering Enabled). If you select IP
Access Filtering Enabled, then you must populate at least one of the three
Allowed Source IP parameters or have no access permitted from any IP
address
Allowed Source IP 1 to
3
If you selected IP Access Filtering Enabled for the IP Access Control
parameter, then you must populate at least one of the three Allowed Source
IP parameters or have no access permitted to the AP from any IP address.
You may populate as many as all three.
If you selected IP Access Filtering Disabled for the IP Access Control
parameter, then no entries in this parameter are read, and access from all IP
addresses is permitted.