Cambium Networks PTP 450 Series, Configuration Manual

Page: 112 / 649

Chapter 1: Configuration General configuration
Page
1-84
Attribute Meaning
Timing Mode Allows the user to choose the mode between Timing Master and Timing
Slave.
Link Speed See Table 22 General page attributes – PMP 450i AP on page 1-72
802.3at Type 2 PoE
Status and
PoE Classification
When the PoE Classification functionality is enabled and if Type 2 power
is not present, the PAs do not power up and draw too much power.
By default, the PoE Classification feature is disabled and the PAs will
power up regardless of the classification presented by the power source.
This is supported only on 450i Series ODUs.
PoE Classification configuration status also can be check under home >
General > Device Information tab:
Sync Input See Configuring synchronization on page 1-106
Free Run Before GPS
Sync
See Configuring synchronization on page 1-108
Region
See Table 22 General page attributes – PMP 450i AP on page 1-72
Country
Webpage Auto Update
Bridge Entry Timeout
Bridging Functionality Select whether you want bridge table filtering active (Enable) or not
(Disable) on this BH.
Disable: allows user to use redundant BHs without causing network
addressing problems. Through a spanning tree protocol, this reduces the
convergence time from 25 minutes to few seconds. However, you must
disable bridge table filtering as only a deliberate part of your overall
network design since disabling it allows unwanted traffic across the
wireless interface.
Enable: Allows user to enable bridge functionality.
Note
Specify the appropriate bridge timeout for correct
network operation with the existing network
infrastructure. The Bridge Entry Timeout must be a longer
period than the ARP (Address Resolution Protocol) cache
timeout of the router that feeds the network.
Prioritize TCP ACK
See Table 22 General page attributes – PMP 450i AP on page 1-72
Multicast Destination
Address