Cambium Networks PTP 450 Series, Configuration Manual

Page: 137 / 649

Chapter 1: Configuration Configuring synchronization
Page
1-109
Aux Port Power to UGPS
The 450 series APs are capable of supplying power to a connected UGPS or cnPulse module via the
Aux/Timing Port. Enable the Aux Port Power to UGPS parameter to output power on the port.
Note
The AP is able to receive GPS sync pulses and satellite data via the Aux Port regardless
of whether this parameter is Enabled or Disabled. However, on the 450m AP and 450i
AP/BHM, the satellite data is displayed on the Sync Status page only when the Aux Port
power is enabled.
Caution
When a UGPS module is used to provide GPS sync to two 450m or 450i APs
simultaneously, it is recommended to install a separate power supply for the UGPS to
prevent the possibility of sync interruption upon reboot of the APs.