Cambium Networks PTP 450 Series, Configuration Manual

Page: 151 / 649

Chapter 1: Configuration Configuring security
Page
1-123
Restricting AP RF Telnet Access
AP Telnet access via the RF interface may be configured in two ways – the AP GUI and SNMP.
Controlling RF Telnet Access via the AP GUI
To restrict all Telnet access to the AP via the RF interface from downstream devices, follow these
instructions using the AP GUI:
Procedure 12 Restricting RF Telnet access
1 Log into the AP GUI using administrator credentials
2 On the AP GUI, navigate to Configuration > Protocol Filtering
3 Under GUI heading “Telnet Access over RF Interface”, set RF Telnet Access to Disabled
4 Click the Save button
5 Once the Save button is clicked, all RF Telnet Access to the AP from devices situated below
the AP is blocked.
Note
The factory default setting for RF Telnet Access is disabled and PPPoE PADI Downlink
Forwarding is enabled.