Dip Switch Features
23
Figure B:
Timer
Figure C:
Delay
Figure A: DIP switches
There are 6 dip switches located at the bottom of the circuit board, Figure A. Each switch controls a
different feature of the gate operator.
Gate Closing Delay
- switch to ON position, turn timer to 1- 6 seconds.
Figure C. Useful for dual gate operators with locks, requiring one gate to
close first before the other, also known as "Bipart Delay".
Auto-Close
- automatically closes the gate after a timed delay. Set to ON
and turn the blue TIMER knob anywhere from 1-60 seconds. Figure B.
Mid-Stop
- allows the remote control to stop the gate when opening or
closing. Press once to stop the gate, and press the remote again to reverse
the gate.
Automatic Close Override
- Pressing the remote control will override the
close timer before the timer ends, allowing the gate to close early.
Dual Gate Installation
- for the secondary gate operator only, set the
#5 SLAVE switch to ON. If single gate installation, set to OFF.
Gate Open Direction
- set the direction of which the gate opens when
viewed from inside the property: Left or Right.
Anti-Tailgating System
- when ON, after a vehicle has cleared the
safety loop, the gate will start to close immediately. If a second vehicle
crosses the loop while the gate is closing, the gate will stop. The second
vehicle must get off the loop before the gate closes completely.
Switch
Name
Description
1
2
3
4
5
6
CL-DELAY
Timer
OSC
1PASS
SLAVE
OPEN L/R
Summary of Contents for CM3
Page 41: ......