1
Minifix-K1Plus
– Series (July 2008-today)
Troubleshooting: K1Plus with square circuit board
Table of content: Page
1)
Gate overview and connector setup………………....2
2)
Gate does not tilt open up…………………………….3
3)
Gate is not lowering down…………………………….4
4)
Gate is not auto tilting down at ground level…....…..5
5)
Gate is not tilting up at ground level..………………..6
6)
Gate is not lifting up.…………………………………..7
7)
Gate is not closing……………………………………..8
8)
Electrical schematic……………………………………9
9)
Hydraulic schematic………………………………….10
*****MAKE SURE YOUR BATTERIES ARE FULLY CHARGED
AND IN GOOD CONDITION*****
Tools needed:
1.) Voltmeter
2.) Test light
3.) 8” jumper cable (16ga. or smaller)
4.) Screw driver flat head or 13mm (1/2”) wrench
