![background image](http://html1.mh-extra.com/html/calimet/cm3/cm3_installation-and-owners-manual_3055112036.webp)
Problem
Gate operator has
no power
Possible Causes
Solution
A. Electrical Outage
B. Circuit Breaker Tripped
C. If using solar panel only (no AC
electrical power), battery level may be
depleted
D. If using solar panel only, battery
may need to be replaced
E. Conduit and/or power cables are
damaged or have corrosion
F. Fuse Blown due to electrical
overload or faulty wiring
G. Circuit Board Malfunction
Gate operator does
not open
A. Check to make sure electricity is
working. If using solar only, give
the gate operator 2-3 days to
recharge the battery.
B. Replace battery.
C. Check for any damages,
obstruction, or misalignment on
the gate.
D. Step on the foot pedal and
move it to the upper-left.
E. Replace circuit board
Gate operator can
open but does not
close
A. Photocell Sensor is not aligned
B. Open direction is reversed
A. Align photocell sensor with the
reflector on the other side.
B. Dip Switch #6: OPEN-L/R on the
circuit board - set to the opposite
position.
Troubleshooting
34
A. Wait until the power comes
back on
B. Reset Circuit Breaker
C. Recharge the battery by using
solar or AC electricity.
D. Replace battery.
E. Replace wiring.
F. Replace fuse
G. Replace circuit board.
A. No Power
B. Remote control has no battery
C. Gate is damaged, misaligned, or
obstructed
D. Foot pedal is set to manual release
E. Circuit board Malfunction
Summary of Contents for CM3
Page 41: ......