California Instruments 12000L-1P, Instruction Manual

Page: 58 / 151

INSTRUCTIONAL MANUAL 2750L-P/4500L-P/6000L-P
August, 2001 Rev. K
-54-
Table 3-12 PROGRAM HEADERS
HEADER EXTENSION ARGUMENT DEFINITION
AMP A, B, C # or numeric from 0.0 to RNG value Amplitude in volts.
CAL A, B, C 0 to 255 Calibrate the output voltage
CAL VLT A, B, C Actual voltage Calibrated measured voltage at external
sense point
CAL CUR A, B, C Actual current Calibrate measured current
CAL PWR A, B, C Actual power Calibrate measured power.
CLK INT, EXT Clock source
CRL A, B, C 0 to maximum current per phase Current limit in amps
DLY 0.000 to 9999 Delay in seconds used as a seconds
ramp parameter
DRP A, B, C 1 through 5 Number of Drop cycles
FRQ 45.00 to 5000 Frequency in hertz
PHZ A, B, C 0 to 999.0 Phase angle in degrees.
PRG 0 through 15 Load register with preceding data
REC 0 through 15 Recall register or specify link register if it
is preceded by program argument
followed by PRG and register number.
REG 0 through 15 Register load
RNG A, B, C 0.0 to 270 or other optional range
value Amplitude range and limit value in volts
SNC INT,EXT Synchronize
SRQ 0, 1 or 2 Service Request disable, enable or at
completion of program and
measurements.
STP From parameter minimum to
maximum value Define step size in ramp.
TLK Any header Set up to talk argument value or
measured value when addressed to talk
TRG Execute (Trigger) set-up parameters on
GPIB "GET" message
VAL From parameter minimum to
maximum value Final ramp or step value in volts, hertz,
amps, degrees, sine wave or square
wave.
WVF A, B, C SNW,SQW Waveform
OPN Open output relays
CLS Close output relays
VLT A, B, C Used with TLK to request measurement
f