MN260 B | 37
Service Manual
7.7.8.5 Cap both ATF ports (Feed and Vacuum ports).
Cap 2X
Figure 7-37. ATF ports
7.7.8.6 Remove the ATF Bulkhead FROM the bottom of the ATF
Module Assembly as shown in figure below.
NOTE: Mark the position for installation.
ATF bulkhead assy
(9922-SEQ)
ATF module assy
(SP9729-SEQ)
Figure 7-38. ATF bulkhead
7.8 INSTALLATION PROCEDURES
7.8.1 GENERAL PROCEDURE
7.8.1.1 Thread Locking Procedure: When applying thread locker
to screws, apply 1 drop of the appropriate thread locking fluid to
the first four threads of the screw/standoffs as show in the figure
below. The Loctite 222MS will be used unless specified other-
wise.
Figure 7-39. Thread Locking Procedure
7.8.1.2 CABLE TIE INSTALLATION PROCEDURE: All cable
ties will be installed using cable tie gun unless specified other-
wise.
Figure 7-40. Cable tie installation
Thread Locker
Summary of Contents for SAROS 3000
Page 56: ...Service Manual 56 MN260 B NOTES...
