C2R 30-005, User Manual

Page: 48 / 183

Colibri serie 6 : User’s guide
© 2000-2012 C2R Technologie, Sarl. All rights reserved.
48 48
Rev. A
Hands Free Time-Out
The Scan Stand and Presentation Modes are referred to as “hands free” modes. If a trigger
command is sent, or the hardware trigger is pulled when using a hands free mode, the imager
changes to manual trigger mode. You can set the time the imager should remain in manual
trigger mode by setting the Hands Free Time-Out. Once the time-out value is reached, (if there
have been no further trigger pulls) the imager reverts to the original hands free mode.
Scan the
Hands Free Time-Out bar code, then scan the time-out duration (from0-300,000
milliseconds) from the inside back cover, and Save . Default = 5,000 ms.
Reread Delay
This sets the time period before the imager can read the same bar code a second time. Setting
a reread delay protects against accidental rereads of the same bar code. Longer delays are
effective in minimizing accidental rereads at POS (point of sale). Use shorter delays in
applications where repetitive bar code scanning is required. Default = Medium.
Reread Delay only works when in Presentation Mode.
DLYRRD500
Short (500 ms)
DLYRRD750
* Medium (750 ms)
DLYRRD1000
Long (1000 ms)
DLYRRD2000
Extra Long (2000 ms)
User-Specified Reread Delay
If you want to set your own length for the reread delay, scan the bar code below, then set the
delay (from 0-30,000 milliseconds) by scanning digits from the inside back cover, then
scanning
Save .