C2R 30-005, User Manual

Page: 19 / 183

Colibri serie 6 : User’s guide
© 2000-2012 C2R Technologie, Sarl. All rights reserved
19
Rev. A
Menu Bar Code Security Settings
C2R scanners are programmed by scanning menu bar codes or by sending serial commands
to the scanner. If you want to restrict the ability to scan menu codes, you can use the Menu
Bar Code Security settings. Please contact the nearest technical support office for further
information.
Setting Custom Defaults
You have the ability to create a set of menu commands as your own, custom defaults. To do
so, scan the
Set Custom Defaults bar code below before each menu command or sequence
you want saved. If your command requires scanning numeric codes from the back cover, then
a
Save code, that entire sequence will be saved to your custom defaults. Scan the Set
Custom Defaults code again before the next command you want saved to your custom
defaults.
When you have entered all the commands you want to save for your custom defaults, scan the
Save Custom Defaults bar code.
You may have a series of custom settings and want to correct a single setting. To do so, just
scan the new setting to overwrite the old one. For example, if you had previously saved the
setting for Beeper Volume at Low to your custom defaults, and decide you want the beeper
volume set to High, just scan the
Set Custom Defaults bar code, then scan the Beeper
Volume High menu code, and then Save Custom Defaults . The rest of the custom defaults
will remain, but the beeper volume settiing will be updated.
Resetting the Custom Defaults
If you want the custom default settings restored to your scanner, scan the Activate Custom
Defaults bar code below. This is the recommended default bar code for most users. It resets
the scanner to the custom default settings. If there are no custom defaults, it will reset the
scanner to the factory default settings. Any settings that have not been specified through the
custom defaults will be defaulted to the factory default settings.