C2R 30-005, User Manual

Page: 67 / 183

Colibri serie 6 : User’s guide
© 2000-2012 C2R Technologie, Sarl. All rights reserved
67
Rev. A
Note: The wildcard for all terminal types is 099.
Step 4. Code I.D. In Appendix A, find the symbology to which you want to apply the data
format. Locate the Hex value for that symbology and scan the 2 digit hex value from the
Programming Chart inside the back cover of this manual.
Step 5. Length Specify what length (up to 9999 characters) of data will be acceptable for this
symbology. Scan the four digit data length from the Programming Chart inside the back cover
of this manual. (Note: 50 characters is entered as 0050. 9999 is a universal number, indicating
all lengths.)
Step 6. Editor Commands Refer to Data Format Editor Commands. Scan the symbols that
represent the command you want to enter. 94 alphanumeric characters may be entered for
each symbology data format.
Step 7. Scan Save from the Programming Chart inside the back cover of this manual to save
your entries.
Other Programming Selections
•
Clear One Data Format
This deletes one data format for one symbology. If you are clearing the primary
format, scan 0 from the Programming Chart inside the back cover of this manual. If
you are clearing an alternate format, scan
1 , 2 , or 3 , depending on the alternate format
you are clearing. Scan the Terminal Type and Code I.D. (see Supported Terminals,
and the bar code data length for the specific data format that you want to delete. All
other formats remain unaffected.
•
Save from the Programming Chart inside the back cover of this manual This exits,
saving any Data Format changes.
•
Discard from the Programming Chart inside the back cover of this manual This exits
without saving any Data Format changes.
Data Format Editor Commands
Send Commands
•
F1 Send all characters followed by “xx” key or function code, starting from current
cursor position.
Syntax = F1xx (xx stands for the hex value for an ASCII code, see
ASCII Conversion Chart (Code Page 1252).
•
F2 Send “nn” characters followed by “xx” key or function code, starting from current
cursor position.
Syntax = F2nnxx (nn stands for the numeric value (00-99) for the
number of characters and xx stands for the hex value for an ASCII code. See ASCII
Conversion Chart (Code Page 1252).
•
F3 Send up to but not including “ss” character (Search and Send) starting from current
cursor position, leaving cursor pointing to “ss” character followed by “xx” key or
function code.
Syntax = F3ssxx (ss and xx both stand for the hex values for ASCII
codes, see ASCII Conversion Chart (Code Page1252).
•
F4 Send “xx” character “nn” times (Insert) leaving cursor in current cursor position.
Syntax = F4xxnn (xx stands for the hex value for an ASCII code, see ASCII