C2R 30-005, User Manual

Page: 56 / 183

Colibri serie 6 : User’s guide
© 2000-2012 C2R Technologie, Sarl. All rights reserved.
56 56
Rev. A
In this example, you are scanning Code 93, Code 128, and Code 39 bar codes, but you want
the imager to output Code 39 1st, Code 128 2nd, and Code 93 3rd, as shown below.
Note: Code 93 must be enabled to use this example.
You would set up the sequence editor with the following command line:
SEQBLK62999941FF6A999942FF69999943FF
breakdown of the command line is shown below:
SEQBLK sequence editor start command
62 code identifier for
Code 39
9999 code length that must match for Code 39, 9999 = all lengths
41 start character match for Code 39, 41h = “A”
FF termination string for first code
6A code identifier for
Code 128
9999 code length that must match for Code 128, 9999 = all lengths
42 start character match for Code 128, 42h = “B”
FF termination string for second code
69 code identifier for
Code 93
9999 code length that must match for Code 93, 9999 = all lengths
43 start character match for Code 93, 43
h = “C”
FF termination string for third code
To program the previous example using specific lengths, you would have to count any
programmed prefixes, suffixes, or formatted characters as part of the length. If you use the
example, but assume a <CR> suffix and specific code lengths, you would use the following
command line:
SEQBLK62001241FF6A001342FF69001243FF
The breakdown of the command line is shown below:
SEQBLK sequence editor start command
62 code identifier for Code 39