C-COM Satellite Systems Inc.
iNetVu™ 7710 Controller User Manual
30
5
–
System Status (status meanings explained in the software section of this report)
AC
ACP Testing
AE
ACP Adjustment on Elevation (During Manual ACP)
AZ
ACP Adjustment on Azimuth
AP
ACP Adjustment on Polarization
CC
Compass Calibration, Reading, Checking and Restoring
DT
Testing
DN
Downloading
EN
TX Enabling
II
Idle
IN
Idle and in Inclined mode
LK
Locking
MP
Motion Detection
MM
Manual Movement
PK
Peaking
PS
Positioning
RD
Reading from Modem
SI
System Initializing
SP
Stopping
SR
Searching
ST
Stowing
UP
Uploading
6
– Receive RF/DVB Signal
Receive RF Signal as measured from the LNB. The letter ‘
N
’ next to the RF Value indicates the
LNB is not being powered properly and there is an issue with the RF connection, whereas no
letter next to the RF value indicates the LNB is powered properly. When the system is not in RF
search Mode, and is searching via DVB carrier, the value represents the DVB signal, and the
letter “L” next to the value indicates a DVB signal LOCK.
7
– Modem Status
Displays the receive strength of the satellite, and the Modem/Transmitter Status.
D
Transmitter Disabled
E
Transmitter Enabled
U
Unknown (Communication with Satellite Modem / VSAT has failed)
(E.g. M140D represents modem signal strength of 140, and transmitter is disabled)
8
– Beacon Receiver Signal
This secti
on represents the strength of the Beacon Receiver Signal (if used). The letter ‘
U
’ next to
the Beacon Signal indicates an unlocked status, whereas the letter ‘
L
’ next to the Beacon Signal
indicates a Locked on satellite status.
