Burstner I 690 G, Instruction Manual

Page: 235 / 304

235
I-Modell - 13/14 - Ausgabe 08/13 - 2354644 - BUE-0056-07EN
Maintenance
12
12.7 Independent vehicle heater
Use the independent vehicle heater for 10 minutes at least once a month with
a cold engine and smallest fan settings.
Before the heating season starts, have the independent vehicle heater
checked by an authorised specialist workshop.
12.8 Replacing bulbs, external
Types of bulbs Different types of bulbs are used in the vehicle. Below, we have described how
to change the different types of bulbs.
On the towel dryer
On the left under the wash basin in front of the rear bed
On the steps to the rear bed to the right and left
Position of the bleeding valves
X
Bulbs and light fittings can be extremely hot. Therefore, allow lights to
cool down before changing bulbs.
X
Store bulbs in a safe place inaccessible to children.
X
Do not use any bulb that has been dropped or which shows scratches in
its glass. The bulb might burst.
Z
A new bulb should not be touched with the fingers. Use a cloth when
installing the new bulb.
Z
Use only bulbs of the same type and with the correct wattage (see
section 12.8.5 "Types of bulbs for exterior lighting").
Z
If LEDs in lights are defect, contact an authorised dealer or service centre.
Fig. 257 Types of bulbs
Pos. in
Fig. 257
Fixture type/bulb
type Changing
1 Plug-in fixture To remove, pull out the bulb
To mount, push the bulb into the socket
with gentle pressure
2 Bayonet socket To remove, press the bulb down and turn
in an anticlockwise direction
To insert, place the bulb in the socket and
turn in a clockwise direction