Burstner I 690 G, Instruction Manual

Page: 224 / 304

224
I-Modell - 13/14 - Ausgabe 08/13 - 2354644 - BUE-0056-07EN
Care
11
11.4 Extractor hood
Clean the extractor hood filter occasionally. How often cleaning is necessary
depends on how often the extractor hood is used. Do not wait to clean the filter
until the performance of the extractor hood has noticeably decreased.
Cleaning the filter:
„
Wash the filter with warm water and some washing-up liquid.
11.5 Air conditioning unit
11.5.1 Dometic
A lint filter and an activated carbon filter are each located in the lower part of
the air conditioning system ceiling unit (Fig. 253,2) behind the ventilation grills
(Fig. 253,1 and 3). The lint filters must be cleaned at regular intervals and
replaced if necessary. The manufacturer recommends replacing the activated
carbon filter yearly.
On the left side of the ceiling unit (outside of the vehicle) is located the
drainage opening for the condensation. Keep the drain openings free from dirt,
leaves or similar to allow the condensation to be drained.
11.5.2 Telair
Every now and then clean the filter and the ventilation grilles on the outside of
the housing. How often cleaning is necessary depends on how often the air
conditioning unit is used. Do not wait to clean the filter and the ventilation grill
until the performance of the air conditioning unit has noticeably decreased.
Cleaning the filter:
„
Wash the filter with warm water and some washing-up liquid.
„
Allow the filter to dry thoroughly before reassembly.
Cleaning the ventilation grill:
„
Use a brush to remove coarse dirt or deposits from the external ventilation
grilles. If a cleaning solution is used, ensure that no water ingresses into
the inside of the housing.
Fig. 253 Air conditioning unit (Dometic)
Z
Only use mild cleaning solutions to clean the filter, never use benzene or
solvents.