Burstner I 690 G, Instruction Manual

Page: 139 / 304

139
I-Modell - 13/14 - Ausgabe 08/13 - 2354644 - BUE-0056-07EN
Electrical system
8
8.8.5 12 V main switch
The 12 V main switch (Fig. 152,6) switches the panel and the 12 V power
supply of the living area on and off.
Exception: Depending on the model, heater, basic light (lighting in the
entrance area), entrance step, spare 4 and a refrigerator with automatic power
selection system (AES) remain ready to operate.
Switching on:
„
Press the upper part of the rocker switch (Fig. 152,6): The 12 V living area
power supply is switched on. The indicator lamp (Fig. 152,5) lights up
green.
Switching off:
„
Press the lower part of the rocker switch (Fig. 152,6): The 12 V living area
power supply is switched off. The indicator lamp (Fig. 152,5) goes out.
8.8.6 12 V indicator lamp
The 12 V indicator lamp (Fig. 152,5) illuminates whenever the 12 V main
switch (Fig. 152,6) is switched on.
8.8.7 230 V indicator lamp
The yellow 230 V indicator lamp (Fig. 152,3) illuminates whenever line voltage
is available at the transformer/rectifier input.
8.8.8 Switch for water pump
Switching on:
„
Press the upper part of the rocker switch (Fig. 152,7): The water supply is
ON.
Switching off:
„
Press the lower part of the rocker switch (Fig. 152,7): The water supply is
OFF.
8.9 Panel LT 510 (Elegance)
Z
When leaving the vehicle, switch off the main 12 V power supply at the
panel. This prevents any unnecessary discharge of the living area battery.
Z
Appliances, such as control units (e.g. solar charge regulator, defroster or
panel) or fitted appliances (e.g. heating, refrigerator or step) continue to
take power from the battery capacity, even if the 12 V power supply on the
panel is switched off. Therefore disconnect the living area battery from the
12 V power supply via the switch on the transformer/rectifier if the vehicle
will not be used for a long period of time.
Z
If the vehicle is not connected to the 230 V power supply and the water
pump is not used for a longer period of time: Switch off the power supply
for the water pump. The pump relay uses around 4 Ah current each day.
Z
The luminance of the LEDs and the symbols adapts automatically to the
ambient light.
Z
The displays can only be called up if the 12 V power supply is switched on.
Z
As soon as a button is pressed, the gauge is automatically illuminated. The
display goes out 20 seconds after the last key has been pressed.
Z
Further information can be obtained in the manufacturer's instruction
manual.