Burstner I 690 G, Instruction Manual

Page: 233 / 304

233
I-Modell - 13/14 - Ausgabe 08/13 - 2354644 - BUE-0056-07EN
Maintenance
12
„
Switch off the hot-water heater and allow it to cool down.
„
Open bleeding valve (Fig. 256,1) and leave open until no more air escapes.
„
Close bleeding valve.
„
Repeat this procedure at all bleeding valves.
„
Check to see if the hot-water heater warms up.
12.6.4 Position of the bleeding valves
Position of the bleeding valves
I 800 (Elegance)
The drain for complete emptying is in the double floor under the water tank (under
the vehicle)
Underneath the driver's and front passenger's seats
In the front bench seat of the central seating group
On the right of the divan
On the heat exchanger
In the kitchen to the side on the top drawer
On the steps to the rear bed to the right and left
I 810 (Elegance) The drain for complete emptying is in the double floor under the water tank (under
the vehicle)
Underneath the driver's and front passenger's seats
In the front bench seat of the central seating group
On the right of the divan
In the lower cupboard to the left of the entrance
On the heat exchanger
In the kitchen to the side on the top drawer
On the garage flap directly on the heater
I 830 (Grand Panorama) The drain for complete emptying is in the double floor under the water tank (under
the vehicle)
On the front left behind a cover in front of the driver's door
Underneath the driver's and front passenger's seats
In the front bench seat of the central seating group
In the storage box of the L-seating group, towards the centre
On the right of the Reliner lateral bench seat
In the lower cupboard to the left of the entrance
On the panel radiator
On the steps to the rear bed to the right and left
I 840 (Aviano)
The drain for complete emptying is in the double floor under the water tank (under
the vehicle)
Underneath the driver's and front passenger's seats
In the front bench seat of the central seating group
On the heat exchanger