Burstner I 690 G, Instruction Manual

Page: 182 / 304

182
I-Modell - 13/14 - Ausgabe 08/13 - 2354644 - BUE-0056-07EN
Appliances
9
The independent vehicle heater can be turned on and off manually or with a
timer. The time for the heating to start can be exactly preselected from
1 minute to 24 hours. It is possible to program three switching on times, of
which only one can be activated. The maximum permitted operation time is
60 minutes.
Switching on the heater for
the base vehicle:
„
Set the heater control to "Warm".
„
Switch on the fan.
„
For continuous operation: Set the fan to the lowest fan setting (due to bat-
tery capacity).
„
To quickly heat up the vehicle: Set the fan to a higher fan setting.
„
Open and close the base vehicle's air outlet nozzles as desired.
Switching on the
independent vehicle heater
manually:
„
Press the button (Fig. 197,7). The heating mode is displayed by the symbol
(Fig. 197,9). The fan will only be switched on when there is a coolant tem-
perature of 30 °C.
Switching off the
independent vehicle heater
manually:
„
Press the button (Fig. 197,7). The symbol (Fig. 197,9) goes off.
Switching on the engine
heating:
„
Press the lower part of the switch (Fig. 197,4). Engine is preheated. The
fan is switched on immediately.
Switching off the engine
heating:
„
Press the upper part of the switch (Fig. 197,4). Engine stays cold.
Setting the time:
„
Press the button (Fig. 197,2). The time setting is displayed by the symbol
(Fig. 197,8).
„
Set the time with the buttons (Fig. 197,3 and 6).
Programming heating start:
„
Press the button (Fig. 197,5).
„
Set the switching on time within ten seconds, with the buttons (Fig. 197,3
and 6).
Selecting programmed
switching on time:
„
Keep pressing the button (Fig. 197,5) until the selected programme
number (Fig. 197,1) appears in the display.
Fig. 197 Operating unit for independent
vehicle heater