Burster DIGIFORCE 9311, Operation Manual, Page: 179 / 216

179
of 216
6.4.2 Deleting a measurement program
If you want to discard all the settings for one or more measurement programs, you can do this using
[Initialize target program(s)] . The DIGIFORCE
®
9311 then resets the relevant measurement programs
to the factory settings. This cannot be undone. The settings of the selected measurement programs are
lost.
Note: As soon as you use [Initialize target program(s)] to delete an existing measurement program,
all the settings in this program are lost.
1 To open the "Copy programs" menu from measurement mode, tap anywhere on the
touchscreen. The icon appears in the bottom-right corner.
2 Tap to open the "Configuration Main Menu".
3 Tap the "Program Copy" icon.
4
Tap
[From target]
to select the first
destination program and then [To target] to
select the last destination program in which
you want to initialize the data.
Note: The data is copied to all the
measurement programs numbered
between [From target] and [To
target] inclusive. If you only want to
overwrite one measurement
program, select the same program
number for [From target] and [To
target] .
5 Tap [Initialize target program(s)] . The
display shows the message "Target
programs will be initialized. All settings will be
deleted!
Note: As soon as you use [Initialize
target program(s)] to delete an
existing measurement program, all
the settings in this program are lost.
6 Tap [ENTER] to reset the destination programs permanently.
7
Tap to return to the "Configuration Main Menu" menu.