Buell 2007 ULYSSES, Service Manual, Page: 85 / 647

1-12 2007 Buell Ulysses: Maintenance
HOME
ENGINE LUBRICATION SYSTEM 1.5
GENERAL
The engine oil level can be checked with the oil and engine at
ambient temperatures (cold check).
However, an accurate reading of the engine oil level can only
be taken with the engine at normal operating temperature
(hot check). Ride motorcycle for approximately 10 minutes to
warm the oil and the engine to normal operating temperature.
NOTE
The engine will require a longer warm up period in colder
temperatures.
Whether a cold or a hot check, the procedure is the same.
During the pre-ride inspection:
●
Check for oil leaks from the oil filter and oil lines.
● Check the engine oil level (cold check).
● Check engine oil level (hot check).
At every fueling stop:
● At scheduled maintenance intervals.
●
When storing the motorcycle.
NOTE
● Engine oil and filter should be changed when fluids are
hot.
● The colder the weather, the shorter the recommended oil
change interval. A vehicle used only for short runs in cold
weather must have the engine oil drained more fre-
quently.
ENGINE OIL LEVEL CHECK
CAUTION
Do NOT operate the engine when the oil level is below
the add mark on the dipstick at operating temperature.
Engine damage will result. (00187a)
CAUTION
Do not overfill oil tank. Doing so can result in oil carry-
over to the air cleaner leading to equipment damage and
or equipment malfunction. (00190a)
CAUTION
Do not switch lubricant brands indiscriminately because
some lubricants interact chemically when mixed. Use of
inferior lubricants can damage the engine. (00184a)
1. The motorcycle must be on level ground, on the side-
stand, with the engine off.
2. See Figure 1-3. Unscrew and remove dipstick from oil
tank/swingarm filler hole. Wipe dipstick clean.
3. Insert dipstick into oil tank filler hole, screwing dipstick in
completely. DO NOT OVER TIGHTEN.
NOTE
The area between the upper and lower registration marks is
the operating range.
4. See Figure 1-4. Unscrew and remove dipstick and read
oil level.
5. If the level is below the lower registration mark, add only
enough oil to bring oil level between lower and upper reg-
istration marks.
Figure 1-3. Dipstick Location/Engine Oil Level
Figure 1-4. Dipstick Oil Level Registration Marks
11107
11500a
Operating Range