Buell 2007 ULYSSES, Service Manual, Page: 256 / 647

2007 Buell Ulysses: Engine 3-17
HOME
NOTE
Remove shop towel from entrance of throttle body to ensure
proper operation of induction module.
13. See Figure 3-12. Connect throttle position sensor (2)
[88].
14. Connect fuel injector leads (3) [84 & 85].
15. Connect fuel line (1).
16. Install throttle body velocity stack.
17. Install air filter base plate. See 4.44 AIR CLEANER
ASSEMBLY .
18. Install muffler. See 2.32 EXHAUST SYSTEM .
NOTE
To remove and install the interactive exhaust system, see 7.6
INTERACTIVE EXHAUST SYSTEM .
19. Install intake cover. See 2.39 INTAKE COVER ASSEM-
BLY .
20. Install rear belt and idler pulley. See 6.6 DRIVE BELT
SYSTEM .
21. Install left side footpeg mount. See 2.34 HEEL GUARD
AND FOOTPEG MOUNTS .
22. Install sprocket cover. See 2.35 SPROCKET COVER .
23. Install chin fairing. See 2.38 CHIN FAIRING.
24. Install air scoops, right and left sides. See 2.40 AIR
SCOOPS.
25. Connect fuel pump. See 4.39 FUEL PUMP .
NOTE
The connection for fuel pump is just above the pump located
at the rear of the fuel tank on the left side of the vehicle.
1 1
WARNING
1
WARNING
Connect positive (+) battery cable first. If positive (+)
cable should contact ground with negative (-) cable con-
nected, the resulting sparks can cause a battery explo-
sion, which could result in death or serious injury.
(00068a)
26. Connect negative ground cable to battery and tighten
fastener to 72-96 in-lbs (8-11 Nm).
1 1
WARNING
1
WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
27. Install seat. See 2.45 SEAT .
Figure 3-12. Fuel Line and DDFI Electrical Connections (Typical)
2
10646a
1. Fuel line connection
2. Connection for throttle position sensor [88]
3. Connections for fuel injectors [84 & 85]
1
3