•
Lower the front roll into the lower
compartment (
1
) and press down firmly the
left and right ends to make sure the cog and
spigot are sitting correctly in their black
plastic housings (
2
&
3
).
Make sure that the cog on the print ribbon is on
the same side as the cog inside the print ribbon
compartment.
•
Insert the fully assembled print ribbon into
the print ribbon compartment, inside the
base unit, as shown below.
•
Place the end of the back roll over the spring
loaded green spindle inside the
compartment. Push the print ribbon up
against the spindle (
1
) and lower the other
end of the ribbon into the compartment (
2
).
Spring loaded green spindle
Print ribbon compartment
1
2
3
2
1
10
Setting up
