register
RSH-EC_Cap_8_en
Rev. 1.0 - 02/2012
22
Perform the following operating steps to install the new lens:
Danger of explosion!
Ensure absolute cleanliness during replacement
work! Ensure that no absorptive substances (e.g. dust) are on the optical
waveguide outlet surface and in the lenses. Use compressed air or a lint
free cloth to remove soiling.
Prior to starting fitting work, ensure that the lens components are clean
by a visual inspection. Non-observance can result in ignition of the
substances by the high light performance and, thus, cause an explosion.
After a visual inspection, manually screw-in the lenses
and tighten using the hexagon wrenches.
Reposition the mismatching protection and fasten it by
retightening the Allen screw.
Final tasks:
•
Carry out adjustment (
see chapter 10 ADJUST-
•
Insert the sensing head into the holder. Observe the
mismatching protection! Lock the sensing head (
see chapter 7 FOCUSING THE SENSING HEAD).
The register sensor is operational again.
