BRP SEA-DOO GTI 130 2019, Operator'S Manual

Page: 52 / 204

CONTROLS
1) Handlebar
The handlebar controls the direction of
the watercraft. During forward opera-
tion, turning the handlebar to the right
steers the watercraft to the right and
inversely.
WARNING
Check handlebar and correspond-
ing steering nozzle operation be-
fore starting. Never turn handle-
bar while someone is near the rear
of the watercraft. Keep away from
the propulsion system.
iBR equipped models
When operating in reverse, steering
direction is reversed. Turning the han-
dlebar to the right while backing up
steers the watercraft to the left. Re-
fer to
OPERATING INSTRUCTIONS
for
detailed instructions.
2) Engine START/STOP
Button
The engine START/STOP button is lo-
cated on the LH handlebar.
All Models Except GTR-X
smo2011-003-018_a
TYPICAL
1. START/STOP button
GTR-X Model
219001840-016_a
1. START/STOP button
Engine Starting and Stopping
Refer to
OPERATING INSTRUCTIONS
for detailed instructions.
Waking Up the Electrical System
Press the START/STOP button once
without installing the tether cord on
the engine cut-off switch.
This will power up the electrical sys-
tem; the information center will cycle
through a self-test function.
GTI and GTI SE Models
The electrical system will stay pow-
ered up for approximately 75 seconds
after the START/STOP button was de-
pressed.
NOTE: If the START/STOP button is
pressed and held without the tether
cord installed, the information cen-
ter displays will stay on as long as the
START/STOP button is held.
Post-Drive Battery Management
All Models Except GTI and GTI SE
This feature allows keeping the electri-
cal system awake to allow using acces-
sories when the engine is turned off. It
also prevents draining the battery too
much when using accessories. When
the battery voltage reaches 12.3V or
less, the system will automatically
shut down to ensure being able to start
the engine.
50
______________
https://www.boat-manuals.com/